dave1888
|
| posted on 12/9/05 at 04:20 PM |
|
|
Megajolt
The Zetec crank position sensor picks up TDC from the flywheel, can you use this set up for Megajolt, or do you need to fit a 36 toothed wheel setup
|
|
|
|
|
paulf
|
| posted on 12/9/05 at 05:17 PM |
|
|
Yes just use the original flywheel trigger, a toothed wheel is only required on older engines or other makes.
Paul.
|
|
|
dave1888
|
| posted on 12/9/05 at 07:02 PM |
|
|
Have you by any chance got a list of components to make up the ver 3 board yet Paul
|
|
|
paulf
|
| posted on 12/9/05 at 09:16 PM |
|
|
Theres a printable list on the megajolt site, everything is available from farnells or RS.I havent made an ordering list up yet, as I need to sort
what parts ive got and then order parts for 6 units.
I can flash the chip with the bootloader if you need one.
Paul
quote:
Originally posted by dave1888
Have you by any chance got a list of components to make up the ver 3 board yet Paul
|
|
|
MikeRJ
|
| posted on 14/9/05 at 12:17 PM |
|
|
quote:
Originally posted by paulf
Yes just use the original flywheel trigger, a toothed wheel is only required on older engines or other makes.
Paul.
As long as the flywheel trigger has 36-1 teeth!
|
|
|
dave1888
|
| posted on 14/9/05 at 08:07 PM |
|
|
I ordered the chip at the same time as the board.
|
|
|
.jpg)
