Boost69
|
| posted on 5/10/06 at 05:26 PM |
|
|
Electrical SVA requirements BEC
Just been thinking. I'm giong to use the wiring loom from the bike. What else would I have to add to the bike wiring to pass the SVA?
Hazzards, fog and reverse, anything else?
Boost.
|
|
|
|
|
rayward
|
| posted on 5/10/06 at 05:29 PM |
|
|
handbrake/brake level warning light
|
|
|
fesycresy
|
| posted on 5/10/06 at 06:06 PM |
|
|
Not for the SVA, but I put in a fan over ride switch, just so I could cool the motor down after a run.
-----------------------------------------------------------------------------------------------------
The sooner you fall behind, the more time you'll have to catch up.
|
|
|
02GF74
|
| posted on 6/10/06 at 06:52 AM |
|
|
reverse lamp is not required. but if fitted, then it is tested - put the wiring in and then fit the lamp later.
|
|
|
Peteff
|
| posted on 6/10/06 at 09:38 AM |
|
|
Handbrake light isn't a requirement either, just the test function.
yours, Pete
I went into the RSPCA office the other day. It was so small you could hardly swing a cat in there.
|
|
|
.jpg){kind=avatar}
