lsdweb
|
| posted on 3/3/11 at 12:05 AM |
|
|
1/4" hex shaft ali knobs?
Hi Guys
A bit of a strange one this! I'm looking for some aluminium knobs to fit a 1/4" hex shaft with a pop up retaining pin. I think early
MG's may have used this kind of fitting for heater controls?
Ideally, i'd like something like this
I've found
Lucas Control Cable & Switch Knob (MGA part AHH5362) on eBay (end time 06-Mar-11 17:32:32 GMT) on eBay but need something a
bit more grippy.
I need them to go onto these these. The plastic knob is
sh*t (although may be IVA friendly) and not suitable for an historic Elan. I'm going to be using two of these switches - lights/horn and
wipers/wash. That's 2 switches on the dash instead of about 5 or 6!
Any ideas?
Regards
Wyn
|
|
|
|
|
Mr Whippy
|
| posted on 3/3/11 at 07:55 AM |
|
|
looks like something of an old gas hob 
Fame is when your old car is plastered all over the internet
|
|
|
