Hammy360
|
| posted on 2/11/11 at 09:47 AM |
|
|
ETB Digidash
Hi,
Been fitting my digidash and after a couple of minor wiring issues its nearly complete.
The problem I have is a totally empty fuel tank and the dash is reading 100%. I currently have a sender that was for a smiths flight fuel guage and
was told it had the same resistance as the etb one. I can swop to etb but before I do that does anyone have any idea of the resistance of the smiths
one? The etb one is 20 ohms full and 260 empty
|
|
|
|
|
Agriv8
|
| posted on 2/11/11 at 10:02 AM |
|
|
long shot is the tank earthed ?
regards
agriv8
Taller than your average Guy !
Management is like a tree of monkeys. - Those at the top look down and see a tree full of smiling faces. BUT Those at the bottom look up and see a
tree full of a*seholes .............
|
|
|
Hammy360
|
| posted on 2/11/11 at 10:14 AM |
|
|
yes and so is the sender on a seperate earth wire
|
|
|
kendo
|
| posted on 2/11/11 at 10:41 AM |
|
|
If the sender is a float on a swing arm type it could be that it is on upside down.
Sounds daft but it happens.
|
|
|
RK
|
| posted on 3/11/11 at 01:15 AM |
|
|
Go into the settings on the dash softwear or just from the unit itself (instructions are pdf on ETB's site), and reverse your settings. Should
be good to go.
|
|
|
Hammy360
|
| posted on 3/11/11 at 08:50 AM |
|
|
all sorted now thanks, I fitted the etb sender
|
|
|
