SJ
|
| posted on 27/4/20 at 07:04 AM |
|
|
Which Fuel Pump Inertia Switch?
I always meant to fit one of these but never got round to it during my build. As I've got the car partially in bits seems to make sense to do it
now.
Question is which cut off switch have people used - there are plenty for about £15 on ebay but not with the connector.
Also, where's the best spot to site one on an MK Indy?
Thanks
Stu
|
|
|
|
|
big_wasa
|
| posted on 27/4/20 at 08:09 AM |
|
|
I am re wiring my Indy at the moment. I found one in my parts bin yesterday so thought it would be rude not to. 
Ford Focus ST170. Ive tucked it up in the foot well as its easy to reach in and reset and close to the fuel pump relay.
I just need some longer bolts.
[Edited on 27/4/20 by big_wasa]
|
|
|
SJ
|
| posted on 27/4/20 at 08:20 AM |
|
|
Thanks for the reply.
I found a Honda switch with wiring on Ebay for £11 which looks like it will do the job. I think I'll mount it on the trans tunnel as that is
where my wiring runs.
Stu
[img]
 
switch
[/img]
|
|
|
JAG
|
| posted on 27/4/20 at 11:30 AM |
|
|
SJ - that's the same one I have. I got mine out of a Rover 200 in a scrapyard.
I located mine on the scuttle bulkhead.
Justin
Who is this super hero? Sarge? ...No.
Rosemary, the telephone operator? ...No.
Penry, the mild-mannered janitor? ...Could be!
|
|
|
SJ
|
| posted on 27/4/20 at 11:33 AM |
|
|
quote:
SJ - that's the same one I have. I got mine out of a Rover 200 in a scrapyard.
I located mine on the scuttle bulkhead.
Justin
Great, thanks. Did you mount it vertically?
[Edited on 27/4/20 by SJ]
|
|
|
JAG
|
| posted on 27/4/20 at 12:26 PM |
|
|
Yes - vertical in all planes if you get my meaning 
Justin
Who is this super hero? Sarge? ...No.
Rosemary, the telephone operator? ...No.
Penry, the mild-mannered janitor? ...Could be!
|
|
|
adithorp
|
| posted on 27/4/20 at 12:40 PM |
|
|
I used the Rover/Honda one. Mounted it beside the dash where I can reach it to reset without getting out.
"A witty saying proves nothing" Voltaire
http://jpsc.org.uk/forum/
|
|
|
SJ
|
| posted on 27/4/20 at 12:45 PM |
|
|
Great, thanks.
This will get fitted as part of the strip down to install by cheap Chinese mini heater and fitting of new dash.
|
|
|
big_wasa
|
| posted on 27/4/20 at 02:11 PM |
|
|
Just need to make sure you can get at it in a hurry if you go over a big bump or something daft.
|
|
|
SJ
|
| posted on 27/4/20 at 02:20 PM |
|
|
quote:
Just need to make sure you can get at it in a hurry if you go over a big bump or something daft.
Thanks
Was planning to mount it on the tunnel in easy reach
|
|
|
