I have just fitted a set of R1 bike carbs to a Pinto 2 ltr engine, it starts and runs, ticks over but does spit occasionally through the zorst. I
noticed if you rev it up the revs don't drop quickly but do return back to tick over after a couple of seconds.
All the linkages are free and the butterflies closing, I seem to remember it is down to setup either to rich or weak and body got an idea I can try?,
I need to drive it around 25 miles to get it setup on the nearest rolling road.
Cheers
Have you added a return spring to the throttle linkage?
As it's quite common for them to be needed,as the bike runs a twin cable set up.
quote:
Originally posted by CosKev3
Have you added a return spring to the throttle linkage?
As it's quite common for them to be needed,as the bike runs a twin cable set up.
quote:
Originally posted by Andi
quote:
Originally posted by CosKev3
Have you added a return spring to the throttle linkage?
As it's quite common for them to be needed,as the bike runs a twin cable set up.
+1
No I haven't but the linkage does return quickly back to its stop point and I tried putting my finger on it but it made no difference.
Cheers
What jets etc have you fitted?
drilled out to 160 and mixture screw turned out 3 turns
Needles at standard height?
yes
Lightweight flywheel?
no, std