I am in the process of building mounts using 3mm plate bolted to the engine and welded to 2" square 3mm wall tubing down to the chassis (where is
sits on a rubber mount). What I am wondering is if 3mm plate for the engine flange is enough, or if I should be using something like 6mm plate?
Thanks,
Shaun
[Edited on 4/2/07 by smdl]
i used 3mm on both my previous cars,never had a prob
Yep, 3mm for me too
Cheers
Alex
Ok its a pinto not a zetec but heres what I've just finished. (a pair of them, drivers side shown but nearside is simmilar).
Well, it looks like 3mm has been used successfully.
Onward!
Shaun