FazerBob
|
posted on 17/1/14 at 12:24 AM |
|
|
Inlet manifold
Rover/MG/Lotus K series inlet manifold. This is the one to use when fitting bike carbs to a Zetec engine.
I have fitted bike carbs to Zetec engines on three cars using a K Series inlet manifold. The ports of this manifold are very close in size and
spacing to the inlet ports on the Zetec cylinder head, making it a good base for fitting bike carbs.
I sold my last kit car a few months ago, and for health reasons will not be having another, so my plans for the manifold are redundant.
This manifold has only been used for 300 miles before the Elise had an upgrade to 135 spec.
I will of course give any help and advice to the purchaser in order to carry out the project.
Price £15 plus postage at cost
[Edited on 17/1/14 by FazerBob]
Bob
Is this a TRADE ADVERTISEMENT?? Click HERE to report it!
|
|
|
will121
|
posted on 17/1/14 at 03:20 PM |
|
|
Do you have a picture of the manifold? As trying to see if it will replace the DIY one I have on my fiesta but not seen one used on a zetec just the
st170 ones
thanks
|
|
FazerBob
|
posted on 17/1/14 at 07:49 PM |
|
|
U2U sent
Bob
|
|
19sac65
|
posted on 22/1/14 at 08:33 PM |
|
|
Is this still a available ?
|
|