Hi, I wonder if anyone had the same experience: The savage switches we have iun our car don't light up sometimes when they should, only after we have pressed and moved them a bit before. Then the connection inside seems to work again... It is the same with 2-3 of the switches and it was the case already when out of the box and tried outside of the car. What can be done to help this? Any ideas?
Thanks!
Gergely

yep i have the same, i put it down to a loose connection , checked everthing on the back and it seems to be fine now

Dodgy earth?

I have some quite cheap maplin connectors as there in a stupid size and a wiggle usually helps but i dont think the build quality is great on them. If its almsot permanent maybe a blob of solder will help. One of ours was sent back as it was the switch at fault though.

bulb/led slack inside switch. This is what we usually find with the square variation of this switch in the workshop.