
As per the title I need help. I have just installed a "new" engine/gearbox into my sons 02 plate 1.6 ford focus. The engine is installed
from under the car. It went in ok with the usual giggle here and there to get around bits. Anyway after it was into postion I looked under the car and
lying on the drive was this pipe. It was at the front of the car roughly under the radiator and was in line with the front of the car, ie side to
side. Now the pipe doesn't have any oil or water in it, it has a flare at each end and looks as as if it was pushed into a pipe up to the flare
at each end. The engine runs ok and does not leak anything. Now I have looked and looked but just cannot see where the pipe comes from or what it
could be used for.
Can the power of the collective provide an answer
[Edited on 13/10/12 by jabs]
[Edited on 13/10/12 by jabs]
Looks like the pressure balance pipe fom the steering rack. There should be a hole in the inner
lip of eack rack boot, fits in there.
quote:
Originally posted by NigeEss
Looks like the pressure balance pipe fom the steering rack. There should be a hole in the inner
lip of eack rack boot, fits in there.
Thanks for the speedy replies, I'll check it out in the morning.
Wow!! don't ya just gotta love this site for answering questions like this.
Today I learned something new. Never seen/heard of this setup before.
quote:
Originally posted by omega 24 v6
Wow!! don't ya just gotta love this site for answering questions like this.
Today I learned something new. Never seen/heard of this setup before.
quote:
Originally posted by omega 24 v6
Wow!! don't ya just gotta love this site for answering questions like this.
Today I learned something new. Never seen/heard of this setup before.
quote:
Originally posted by jabs
quote:
Originally posted by omega 24 v6
Wow!! don't ya just gotta love this site for answering questions like this.
Today I learned something new. Never seen/heard of this setup before.
Totally agree, this site is wonderful and the depth of knowedge knows no bounds