Board logo

Cooling pipe's
t11 - 23/12/12 at 04:24 PM

Hi All.......does any one know where I can get some water pipe's made up, they have to run side by side with 90deg bends at either end, I've tried Merlin motor sport but they can only do a radius of 112mm...any idear's.........

mark chandler - 23/12/12 at 05:07 PM

I used 1" central heating copper pipe and soldered 90 degree elbows.

russbost - 23/12/12 at 05:22 PM

I can make up anything you want in ali tube in either 25mm or 32mm, with beaded ends but I will need to check what minimum radius is I can do, I have a suspicion it may be same as Merlin

renetom - 23/12/12 at 05:58 PM

Hi
I agree 22 or 28mm copper pipe
With 90 degree yorkshire elbows.
Cheap as chips, job done.
Good luck
René

[Edited on 23/12/12 by renetom]

austin man - 23/12/12 at 07:13 PM

you could always cut it at 45 degrees and weld or fit samco elbows

britishtrident - 23/12/12 at 07:15 PM

Use straightish hoses with bends or black plastic 90 degree bends used for Koi ponds and irrigation.

T66 - 23/12/12 at 07:35 PM

Truflex stainless will bend, guy on Ebay will sell you lengths of your choice.