avagolen
|
 posted on 12/12/10 at 04:05 PM |
|
|
Mazda 6 particulate filter
Good afternoon everyone,
- Does anyone have any knowledge of this system.
A friends Mazda 2.0 diesel keeps on complaining that there is a problem with the unit. The cat and filter - being a single unit - has been replaced
and still complains that the unit is blocked. It has been reset but immediatly sets again.
If the sensor is duff, what signal information would I be looking for - analogue or digital (meter or scope required)
At the moment, the ECU keeps the car in a very low power mode - not enough to tow with. 
Any constructive information would be welcome, Thanks.
Len.
The Answer for everything, but never the last word....
|
|
|
|
|
JAMSTER
|
| posted on 12/12/10 at 04:17 PM |
|
|
had this last week 2.0 mazda 6 . we fitted new dpf tryed to reset it with snapon modis no joy .went to mazda they reset it and it's all good
now. hope this helps
|
|
|
avagolen
|
| posted on 12/12/10 at 05:04 PM |
|
|
Thankyou for the response.
The previous reset was done by the AA so hopefully we will get the same result with Mazda doing the reset.
Len
The Answer for everything, but never the last word....
|
|
|
jonesier1
|
| posted on 12/12/10 at 06:42 PM |
|
|
to test the sensor you need a scanner to look at live data.With a miti vac apply a small vacumn to the sensor and check the reading to see if its the
same.
im in my own little world...its ok though they know me there
|
|
|
jonesier1
|
| posted on 12/12/10 at 06:42 PM |
|
|
to test the sensor you need a scanner to look at live data.With a miti vac apply a small vacumn to the sensor and check the reading to see if its the
same.
im in my own little world...its ok though they know me there
|
|
|
avagolen
|
| posted on 12/12/10 at 08:12 PM |
|
|
Thanks, if the Mazda reset does not work, I will try it.
Len.,
The Answer for everything, but never the last word....
|
|
|
