DaveFJ
|
| posted on 15/9/04 at 08:34 AM |
|
|
Tiger Loom
OK this discussion was started in another thread but I thought it was probably best to start a fresh one......
First off let me apologise for the length of this post......
Been working through my Tiger loom labelling all connectoions to try and make life easier a little later on.......
I have been using the file from the yahoo tiger group which has been very helpful - so far!
I am now left with quite a few unidentified wires. The ones i have left to identify are below:
PLUG NEAR FUSE BOX - (wiper motor ?)
white
black
red
red/blue
MAIN BRANCH UNDER DASH (HAS 3 SEPERATE BRANCES)
BRANCH1 - (ignition ?)
brown
white
white/red
BRANCH2
green
lt green/black
twin green
brown/lt green
red/lt green
blue/lt green
BRANCH3
lpurple (long) - horn ?
black
green/white - indicators ?
blue
lt green/brown - indicators ?
green/red - indicators ?
blue/red
blue/white
NEAR RADIATOR - (rad temp switch ?)
black/red
2 x purple
there are also a couple of odd wires near the dizzy connectors which don't seem to marry up with anything.
I have identified all circuits listed in the spreadsheet except the following (colours shown are those listed on the spreadsheet):
Rad fan switch (brown, red/lt green)
Coil (white, white/black)
fuel shut off valve (white/green)
choke switch (white/green)
Also I have noticed that there is no mention of indicators switches in the spreadsheet so i am guessing that these are in branch3 above.
apologies once again for the length of this post.....
Cheers
Dave
"In Support of Help the Heroes" - Always
|
|
|
|
|
tigertom
|
| posted on 15/9/04 at 01:08 PM |
|
|
I had the same problems but after a lot of phone calls to tiger I eventually got it sorted out.
|
|
|
tractorboy
|
| posted on 16/9/04 at 07:30 PM |
|
|
try phoning the tiger london rep. hes a guy called richard on 0208 3178355 . very helpful ,pleasant chap.
|
|
|
Avoneer
|
| posted on 16/9/04 at 09:51 PM |
|
|
www.thetigeravon.co.uk
I did a full legend to try and help everyone.
Pat...
No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.
|
|
|
DaveFJ
|
| posted on 17/9/04 at 10:37 AM |
|
|
Pat
I have just checked and the spreadsheet i have used so far is the one you created (thank you very much) 
Unfortunately i have 'found' almost every connector on your sheet and i still have the ones listed above 'spare'
Your effort is greatly appreciated though!
Cheers
[Edited on 17/9/04 by protofj]
Dave
"In Support of Help the Heroes" - Always
|
|
|
DaveFJ
|
| posted on 17/9/04 at 10:48 AM |
|
|
Cheers Scott
just phoned Richard and he has helped me a bit - now at least i know where to look!
Dave
"In Support of Help the Heroes" - Always
|
|
|
DaveFJ
|
| posted on 20/9/04 at 03:10 PM |
|
|
Sussed it !!
Although i had a copy of Pat's spreadsheet, I didn't have a copy of his diagrams showing the stalk switches... all sorted now
Cheers Pat - your a star
Dave
"In Support of Help the Heroes" - Always
|
|
|
%20(WinCE).JPG)
