hiya all are there any people building in wales . cant be just me and the sheep. seems everyone is miles away. finding donors is the same nothing around here. all been nicked and burnt out

Welsh Porn



Sorry, couldn't resist

Lenny is in Wales isn't he? He posted about just getting his kit recently.

hey ben we s*~@G em you eat em

Sure you shag them and eat them

thats all the english girls he he he

does anyone know of any good scrappies in the south wales/west england area its pants around here

Good ones in Reading, if you dont mind the trip

im from wales, but up north, not far from chester, and so in JohnN.
im at uni down in bristol too, so prob not all that far away from you - where abouts are u?
shame my cars being build at home though, but i guess its for the best as far as my studies are concerned.
all the best,
tom

I'm from wales. spend a lot of time there, but the car is in Berkshire (a short drive down the M4.

Adam

I'm in wales, Swansea.

Still looking for my perfect kit not sure wot to go for, or how much work I want to do.

and still gotta learn how to weld properly, havent done any in years since metal work at school, and even then I remember my teacher describing it as bird poo!

So where are you based then???

i;m in wales guys, i know tom is welsh ive spoken to him once before,

i also know smooth torquer is from wales

to answer the original question, i am building a middy but untill i have the time to design and build it properly with the time it deserves i am gioing to build an mk indy

not just sheep here after all.
hiya all. im near chepstow second severn crossing in my back garden.

would'nt worry about the welding phelpsa unless your building a book car should'nt have to do much, if any.

so whats is everyone building

andy

Same as you mate.. A Luigi Viento. Black and Polished Stainless. (Shudda saved the money! - See below!)

Got some of the brake pipes in today.
Got the wings in the loft, and hope to get a LSD axle tomorrow.
I had already got a set of Drums, diff, and shafts, only to find out they recommend rear discs, and you need different uprights for drums.

SO... I have decided to get Disc's all round. (more blinking unplanned expense). Shudda got a Donor car in the first place

Also found out the Sierra front uprights need the bottom taper hole reaming out to fit the Maxi ball joint properly. Found that out when I picked up the chassis. Damn and BLAST... as they would have done it whilst I was there.

I think I may need another trip to Looey Agoe's, at least they are decent people...

Got it Saturday, and only done 4 brake pipes!.. but I did make them up all myself.

I will get it all done eventually. I had hoped to have a rolling chassis with the engine in by now!

Its going a bit slower and the wind from the notrh is blowing straight in the open side of the car port... Brrrrrrrrrrrr