All these bits for a Sierra based Ron Champion locost. Tried to sell as a job lot but no takers:


sierrra uprights
Ball joints

s/h Sierra uprights with adaptors, top and bottom ball joints (new) £ 90


Disk brakes
calipers
Recon Sierra Calipers and new disks with a bit of surface rust from sitting around. £70


wishbone plates
2 pairs laser cut wishbone plates £20 per pair


type 9 Gearbox
Type 9 gearbox with stick and chassis cross member £95


capri axel
rear brakes

Capri rear axel with pair of 9" drums and backplates with seal kits £75


prop shaft
Propshaft 810mm overall length needs a new hardy spicer at gearbox end which is spline for type 9 £30


rims
rim
Set of 5 laser alloys all similar need proper refurb £65 the set


tacho
50mm Smiths tacho £25


water temp
water temp guage 50mm £15


hazzard switch
Hazzard warning light switch £5


master cylinder
Sierra Master cylinder with reservoir and cap probably needs new seals £15


Chassis
chassis detail
Ron Champion locost chassis, good standard of welding needs stripped and painted £120



rod ends
Rod ends for Panhard rod £20

All plus postage / courier at cost but would prefer stuff picked up, particularly the big bits. Cash or Pay Pal.

Caber

there wasn't a sierra based ron champion locost
i suspect these are for the chris gibbs haynes roadster perhapd?

What size disc are the front calipers for? Vented or solid?

Cheers
David

@blakep82, before chris gibbs book came out there were rather a lot of Ron Champion locosts built with sierra doners due to lack of Escorts. Mine has a real mix of parts including sierra engine, gearbox and other things. As Cortina uprights are also rare Sierra ones were also sometimes used. You could use bits to build a Chris Gibbs roadster but chassis and back axle would not work

@minicooper, the calipers and disks are a set. The disks are vented and sierra size to fit the uprights, next time I gp to lock up I will measure but this may not be until next weekend.

Caber

Thanks Caber, whatever size the sierra calipers/discs turn out to be, I believe either 240mm or 260mm is usual sierra sizes, did you try them for fitment inside the laser alloys which I think are 13" like my current wheels are? This information would help me either way if you did

Cheers
David

Disks 255 dia. And do fit in 13" wheels with calipers

Caber

Does nobody want any of this stuff? Is anyone building Locost sanymore?

Caber

bump?