I am spending a lot of time and money getting sheet MDF/plywood cut into parts.
Anyone know anything about small scale CNC/laser cutting machines?
[Edited on 18-6-12 by designer]
I'd looked into getting some mdf bits cut for templates, surprisingly to me it was cheaper to get them done in steel.
A CNC laser cutter that's going cut anything decent will cost sever thousand $ even if done DIY try looking at:
http://www.instructables.com/id/CO2-laser-that-cuts-sheet-metal/
My advice would be to find a cheaper cutting service, I was mostly surprised how cheap jobs were that'd I'd got done, but that was in
Australia, so probably not of much use to you.
[Edited on 19/6/12 by Doug68]
Doesn't have to be Laser, MDF and ply could be cut with a CNC router. Try signmakers
Cheers
Fred W B
quote:
Originally posted by designer
I am spending a lot of time and money getting sheet MDF/plywood cut into parts.
Anyone know anything about small scale CNC/laser cutting machines?
[Edited on 18-6-12 by designer]
quote:
Originally posted by Fred W B
Doesn't have to be Laser, MDF and ply could be cut with a CNC router. Try signmakers
