jimgiblett
|
posted on 25/4/12 at 02:01 PM |
|
|
Metal polisher
Hi I am looking to have my cam cover de-lettered and mirror polished. I had a quote from a guy on ebay a little while back of £70 but am not getting
any replies to the emails.
Anybody recommend a good polisher.
Cheers
Jim
|
|
|
maccmike
|
posted on 25/4/12 at 02:21 PM |
|
|
do it yourself;
angle grind letters off
Then sand with gradually finer paper
Then buff with polishing paste and polisher.
Be able to buy all stuff for less than the quote
|
|
jimgiblett
|
posted on 25/4/12 at 02:26 PM |
|
|
I did consider this but there are loads of nooks and crannies so will take me an age and will probably look cr8p. I am also so busy at work at the
moment I dont think I'd get it done.
Annoyingly it is just too big to fit in the dishwasher so I havent been able to degrease it
- Jim
|
|
TAZZMAXX
|
posted on 25/4/12 at 04:11 PM |
|
|
I wouldn't even attempt it myself and we have most of the polishing equipment at work to do stuff like this. Polishing is a soul destroying and
dirty job but a good polisher will make light work of it and make it look easy. Trust me, if you start it yourself, you'll wish you'd paid
to have it done. Some aluminiums just won't take a mirror polish and it could end up looking worse for it. Even at £100 it would be money well
spent.
|
|
bi22le
|
posted on 25/4/12 at 08:23 PM |
|
|
Thats if the guy does a good job.
If its a PITA and charging £70 he may not be that good.
Just a thought.
Oh, and I would attempt almost anything myself but I could not be ar$ed with that!!!!
Track days ARE the best thing since sliced bread, until I get a supercharger that is!
Please read my ring story:
http://www.locostbuilders.co.uk/forum/13/viewthread.php?tid=139152&page=1
Me doing a sub 56sec lap around Brands Indy. I need a geo set up! http://www.youtube.com/watch?v=EHksfvIGB3I
|
|
MakeEverything
|
posted on 25/4/12 at 09:30 PM |
|
|
I would mill the letters off, sandblast the whole thing and powdercoat in a silver colour.
Kindest Regards,
Richard.
...You can make it foolProof, but youll never make it Idiot Proof!...
|
|
Confused but excited.
|
posted on 25/4/12 at 09:36 PM |
|
|
Or go for a satin anodised finish to match the inlet manifold. Not as expensive as you might think
Tell them about the bent treacle edges!
|
|