My paddleshift arrived today, can any one tell me if there is anything to hold the piece that slides over the column on or is it such a tight fit that it stays put. (hope that makes sense to someone)

Just ask AB performance, they sold it.

Didn't you ask about it when you ordered?

on the paddleshift tube aren't there a couple of small threaded holes with grub screws that once tightened dig into your existing column to hold the whole assembly in place?

[Edited on 27/3/12 by andyfiggy2002]

No there is a hole each side of the tube i have to drill and tap a hole each side of the colomn so that i can put a bolt in to hold it apparently.