I've had this hanging about for ages and tbh I'm not going to use it - so anyone interested at £120+p&p? Just the bare alloy casting btw
but it's never been fitted to a car so in very good condition. They cost £200ish to buy new so quite a saving if you're after one?
[Edited on 24/7/08 by D Beddows]
hi,
I have to change gearboxes and engine
I am putting in another 2L zetec (not yet sure if blacktop or silvertop, and using a type 9 gearbox
would that fit?
Unfortunately no, the bell housing is for Zetec SE engines ie the 1.25, 1.4, 1.6 and 1.7 type found in Fiestas, Pumas and Focus's. The bolt
pattern is completely different to the 1.6, 1.8 and 2.0 Zetec E engines.
As it's been bumped.....anyone else? I'll let it go it for £130 posted to the UK.......
quote:
Originally posted by les
hi,
I have to change gearboxes and engine
I am putting in another 2L zetec (not yet sure if blacktop or silvertop, and using a type 9 gearbox
would that fit?
Bit of a blast from the past I know but I've just put this on ebay - so in the seemingly unlikely event that any of you are interested :-
Ebay Linky
Hi, I know l'm dragging up an old post did you ever sell your zetec se bellhousing?
Old post???? its 6.5 years old lol
If you need one the following can supply (or could six months ago when I got mine)
Shawspeed (got mine from there)
Rwd motorsport
Tiger racing
Caterham
Westfield