how to do it? fitting gotech management system and need to get rid of the mechanical advance the dizzy does

You will need to dismantle the unit. Inside you will find two bob weights that are controlled by springs, these will need to be either removed and the advance plate spot welded to the shaft, or leave them on and spot weld them so they can't move, probably the easiest thing to do. HTH Ray

cool thanks, is there a howto somewhere on dismantling it?

Haven't seen one, but sure there must be somewhere, have you Googled it? Usually find something on there. Cheers Ray

if you are talking the carbed version for a pinto, then knock out the roll pin that hold the gear wheel on, and it all falls apart once thats out

dave

quote:

---

Originally posted by dave r
if you are talking the carbed version for a pinto, then knock out the roll pin that hold the gear wheel on, and it all falls apart once thats out

dave

---