Can someone with 6x13 CXRs, and someone with pro race 1 or 2's measure the diameter of the inside of the wheel level with the hub mounting face. Could you then post the offset, the measured diameter and perhaps a photo of the inside of the rim for me?

Cheers

i should be home at the weekend so will get you some measurements then.

pro race 1.2's

if you asking what i think you are, i had to change to fiesta front disks (turned down hub) and then move the calipers in a few mm.

and i think i know the question too...

i have sierra rear calipers. they fit if you take off one turn on the handbrake spring.

i can get you a photo tomorrow probably once i get the car back over the pit.

close, but no cigar!

Im trying to fit mazda uprights with 254mm vents and wilwood superlites, so I figure no one would know if that fitted or not, hence the measurements.

Rear will be on 231mm solid disks and more than likely 7 inch rims so shouldnt be an issue.

Dan, if you could get measurements at the weekend that would be great!

quote:

---

Originally posted by speed8
and i think i know the question too...

i have sierra rear calipers. they fit if you take off one turn on the handbrake spring.

i can get you a photo tomorrow probably once i get the car back over the pit.

---