I'm using a fiat cinquecento steering column and now I'm doing the wiring, I realise the headlight switch only goes between dipped and main beam (with flash). On the other side, there is a wiper switch with 2 speeds. I'm thinking of using this for off-side-headlights. I can remove the wiper symbol easy enough but then I'm left with no symbol. I don't mind but will the MSVA inspector object? Can you get stick on headlight symbols?

Hi ya

Yes i beleive you will need them to be labbeled.

I am planing on using these Dash, Switch, Symbol Sticker Sheet, Rally, Kit Car, on eBay (end time 12-Oct-10 10:48:43 BST)

Hope that helps

[Edited on 15-10-10 by davrus]

Yeh you can buy a sheet full. I bought some for just the horn symbol.

If there is some you need I will see if I can find them for you.


Dash, Switch, Symbol Sticker Sheet, Rally, Kit Car, on eBay (end time 19-Oct-10 11:35:29 BST)

Paint them, I've had some cars that old and used it's worn off

Labelling of switches is something that was tightened up considerably in IVA compared with SVA.

As you're doing MSVA I doubt it will be a problem, but check the manual. Fitting a sticker isn't much of a hardship though.