my new engine needs a 5bar fuel pump, i've got one however i've decided to run a twin in tank set-up like the DTM race cars did.

I need to create a fuel return fitting on my tank.

I'd like to drill the tank and fit a hose connector like this...

BRASS HOSE CONNECTOR 1/4' BSPT - 5/16' 8mm HOSETAIL 2pk | eBay UK

However i'm looking for one that will bolt either side of the tank if that makes sense? Not a screw in one.

Any pointers?

https://secure1.actinicexpress.co.uk/shops/partsforaircraft/index.php?section=64

7th down on the right.

Not exactly what you asked for but just an idea.

[Edited on 25/4/11 by big_wasa]

yep, cheers for that, just found these too, an M10 nut on the back should do the trick also.

M10 x 1.0 Thread to 8mm I/D Hose Fuel Connector on eBay (end time 08-May-11 14:22:01 BST)