Cheers, Pewe10
Total b*llocks ^^ they are 3/4 either UNC (most likely) or UNF but you should be able to tell by looking at the thread whether it's coarse or fine.
Note to self : buy some more self locking t/end nuts!
[Edited on 1/4/12 by pewe]
Hi can any one help?
I've just ordered some new Nyloc nuts for Track rod end's M10 1.25 Fine thread but they don't fit.
Have i ordered the wrong thread or have they sent me the wrong size?.
Mk2 Escort track rod ends.
IIRC they are 7/16 UNC or UNF - give me 20 mins and I'll shoot into the garage to check.
Cheers, Pewe10
Total b*llocks ^^ they are 3/4 either UNC (most likely) or UNF but you should be able to tell by looking at the thread whether it's coarse or
fine.
Note to self : buy some more self locking t/end nuts!
[Edited on 1/4/12 by pewe]
It may depend on who made the track rod ends ? the only safe way is to measure the thread using a set of thread gauges and a vernier