Hi guys,

Have been searching for ages for a 2” 90 degree bend and outwardly rolled but can’t find one.
Anyone got any ideas?

Thanks
Andy

I couldn’t find one sensibly priced either and stainless is hard to form so I welded one on with a straight slash cut.

I made my first one but later came across custom chrome from Nuneaton at the national kitcar show. They will make anything. They made me a 2" stainless tailpipe with a 90deg bend and rolled edge to my exact measurements and were not expensive (£14 inc post??). You can find them on facebook or https://www.cherrybomb.co.uk/ and I think other sites as well

Thanks both, will definitely try the custom chrome guys!

I had the same problem. I had a 80 degree bend kicking around and ordered a 6mm thick mooring ring on ebay. Welded it on the tip of the pipe then fettled it back with a belt sander. Has come out spot on. The mooring ring was less than £2.