Board logo

Metal lathe...
CraigJ - 1/7/07 at 03:08 PM

I need the small shafts on my chain diff taking down a little so the bearings will slide on better as i cant get them on straight enough. Any suggestions? I live a few miles from where the yorkshire meet is held so around this area would be great.


Wadders - 1/7/07 at 06:45 PM

Hi Craig
How long/what diameter are they?
For absolute accuracy, you might be better finding somewhere that can do cylindrical grinding, but i'm happy to have a go in the lathe for you. I live in Oulton near Rothwell, 5 minutes from junc 36 M62, i'd need the bearings to get a good fit.

ATB
Al.



Originally posted by CraigJ
I need the small shafts on my chain diff taking down a little so the bearings will slide on better as i cant get them on straight enough. Any suggestions? I live a few miles from where the yorkshire meet is held so around this area would be great.



CraigJ - 2/7/07 at 05:46 PM

Hi, thanks for the offer but ive just been to see about it at a place in whitwood. If they cant do it i'll give you a shout.

Thanks very much Craig.