Miks15
|
 posted on 2/4/10 at 11:25 PM |
|
|
inside diameter of team dynamic wheels - again
One more question, is the inside diameter of the Team Dynamics wheels constanst from outside to mounting face?
Reason i ask is my 15" BMW wheels wont quite fit because they narrow a bit towards the mounting face of the wheel so they hit the caliper.
Cheers
Mikkel
|
|
|
|
|
franky
|
| posted on 3/4/10 at 09:45 AM |
|
|
Hi,
Its a good point, I tried fitting some on to my car and due to how they narrow it was a no go.
The 'better' quality the wheel the more constant the inside diameter seems to be.
|
|
|
Miks15
|
| posted on 3/4/10 at 09:59 AM |
|
|
are you talking about BMW rims or TD rims narrowing?
|
|
|
franky
|
| posted on 3/4/10 at 11:14 AM |
|
|
In general.... I tried a few old(cheap) bmw and aftermarket rims on and they seemed to narrow by a decent amount but when I tried some more expensive
rims they had a more constant radius on the inside. It may just have been a fluke observation though.
|
|
|
v8kid
|
| posted on 3/4/10 at 11:51 AM |
|
|
they taper as they go inwards to allow them to seperate from the tooling when released. typically the radius decreases by 3mm
|
|
|
Miks15
|
| posted on 3/4/10 at 01:09 PM |
|
|
Ok thanks,
Does anyone know the inside diameter of 15" TD wheels by the mounting face?
Thanks
Mikkel
|
|
|
