johnemms
|
| posted on 4/8/11 at 08:06 PM |
|
|
Bizzy day
Bizzy day today 
Cut the stupid oversize Robin Hood Flange to smaller size...
Welded n fitted the four into one ...
Chatting to a guy in a repair shop who sold me 2 used hoses for £5... They Fit !!!
Had a very hot shower and scrub - took son to carvery for lunch...
Should be thinking about bed.. Thininking about ordering a prop shaft 
[img] [/img]
Jon
|
|
|
|
|
SeaBass
|
| posted on 5/8/11 at 08:28 AM |
|
|
Takes me back - just like my build in 2002
|
|
|
D Beddows
|
| posted on 5/8/11 at 09:36 AM |
|
|
Indeed - for a site called 'Locost'builders there are alarmingly few people who are actually building a Locost from the plans anymore -
which I think is a shame. Nothing wrong with just going out and buying everything then just bolting it together and fitting the biggest engine you can
afford but it's just not the same......... ahhh the good old days in 2 months I'll have been a member of this forum for 10 years which
is quite scary 
[Edited on 5/8/11 by D Beddows]
|
|
|
Trollyjack
|
| posted on 5/8/11 at 06:31 PM |
|
|
Well there are still some of us building one
In early stages Front suspention about done
Currently working on rear axle
Got a 1300 crossflow to go in
Funds low not plannibg on getting it finished this year may be later next year
Some pictures in Photo Archive
Comments welcome
TrollyJack
|
|
|
Mark Allanson
|
| posted on 5/8/11 at 08:42 PM |
|
|
When was the last time we saw a post asking how to fit FU and FU too?
If you can keep you head, whilst all others around you are losing theirs, you are not fully aware of the situation
|
|
|
rusty nuts
|
| posted on 6/8/11 at 07:36 AM |
|
|
At least cutting the flange the way you have allows the manifold to flex enough to get the gaskets to seal against the head which it probably
wouldn't due to the massive amount of distortion in the flange . I just cut my flange into 3 without cutting it off completely but I did have to
reweld 1 of the joints that hadn't been welded properly . Still you get what you pay I suppose? It might be a good idea to think about a
heatshield between the alternator and the manifold?
|
|
|
.jpg)
