liam.mccaffrey
|
| posted on 23/11/05 at 12:07 AM |
|
|
Laser/Water cutting
I am thinking of having some of this done and was wondering If anyone else has done the same
I have read the following thread naming this company who had been helpful http://www.esplaser.com/
thread
Any views/opinions/experience
[Edited on 23/11/05 by liam.mccaffrey]
Build Blog
Build Photo Album
|
|
|
|
|
Volvorsport
|
| posted on 23/11/05 at 11:57 AM |
|
|
i have a freind who works at micrometrics in lincoln - same company that laser cut the steering components for Ayrtons car 
completely exonerated of course !!!
what do you have in mind ?
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
dnmalc
|
| posted on 23/11/05 at 12:45 PM |
|
|
I think Fozzie has been playing around with plasma cutters she may be able to help
|
|
|
liam.mccaffrey
|
| posted on 23/11/05 at 05:03 PM |
|
|
I wanted specifically an inlet manifold plate for my ecotec but, If it is not too costly there are literally piles of things i could draw up for
cutting. I'm a draughtsman see
Volvosport, some of your pro Volvo talk on here is getting my attention could be a contender for my next project
[Edited on 23/11/05 by liam.mccaffrey]
Build Blog
Build Photo Album
|
|
|
Simon
|
| posted on 23/11/05 at 11:52 PM |
|
|
We use these guys
http://www.sciss.co.uk/
for stainless/ally/phospur bronze/marble/granite and slate.
HTH
ATB
Simon
|
|
|
Volvorsport
|
| posted on 24/11/05 at 03:18 PM |
|
|
if you can get a drawing with a dimension on it , i can certainly give it too him , they can do most things .
good to hear about the new project , i keep finding unique things , that make it even more viable , from a donor vehicle point of view !!!
www.dbsmotorsport.co.uk
getting dirty under a bus
|
|
|
