piddy
|
| posted on 14/3/06 at 11:15 PM |
|
|
master cylinder washer
Hi.
I'm using the Girling m/c with a bias bar as supplied by a lot of the manufacturers.
These have a screw in nipple to attach the pipe to connect to the reservoir.
What is the washer between the M/C and the screw in nipple made of? Is it a fibre washer or is it special?
|
|
|
|
|
Liam
|
| posted on 14/3/06 at 11:23 PM |
|
|
I believe you normally use copper crush washers in that sort of fitting to get a good seal.
Liam
|
|
|
Nick Skidmore
|
| posted on 15/3/06 at 11:08 AM |
|
|
That's correct, try a hyraulics supplier if you have one local, for local people.
|
NOTE:This user is registered as a LocostBuilders trader and may offer commercial services to other users
|
