Simon
|
| posted on 23/9/06 at 08:39 PM |
|
|
Thick wall ally tube bends - where from?
Chaps,
I'm looking for some ally tube about 65mm ID with a 3-4mm wall with a 90 deg bend (tight as poss )
Needed for my intercoolers to plenum
Cheers for suggestions!
ATB
Simon
|
|
|
|
|
tks
|
| posted on 23/9/06 at 08:50 PM |
|
|
wy do you need 3/4mm wall??
a couple of psi doesn't need that!
just make sure you can flair the border to have grip with the hose clamp!
someone on hear had made a nice tool for ally!
Tks
The above comments are always meant to be from the above persons perspective.
|
|
|
Simon
|
| posted on 23/9/06 at 11:44 PM |
|
|
Cos it's gonna have to support the weight of two intercoolers, and I need to weld them together to form a double U (UU)
ATB
Simon
|
|
|
froggy
|
| posted on 24/9/06 at 12:33 AM |
|
|
thick wall ally will bend in steam pipe bender but the rad isnt very tight about 8" rad on my bender. the only thing i can think of is an ally
weld-el from a pipe fitting supply firm as i know you can get a 2" 90 degree steel version
|
|
|
