Looking for a 7" 3.38 diff. Whole diff or crown wheel in pinion.

Have you looked/searched for sale section?
Has been at least two for sale recently.

I have one. Make me an offer.

Ok, what you got? A std push in shaft 3.38? Condition, have you had back off & checked it, or used it? I'm a write in thinking I can use crown wheel & pinion to go into my xr4x4 Lsd diff I have?

Used standard push in shafts. 3.38 ratio. Not had back off. Have had it in car and works fine. As far as I know you are right about being able to convert your current one to 3.38 ratio but there will be others better placed to answer that than me.

U2u sent, I think!!

I have one kicking around, its been welded locked but CWP still good condition.

Wont be back in country until 8 Dec Though, if you are still looking then