nice little HF inverter tig, around £500 new, might be cheapish?
GYS 160 HF tig
damn thats local nat, bet you're gutted you had to drive miles for yours...
doesn't do AC though - Nats does
ah yesh opps 
Just to bring this back to the top, please somebody on here buy this it is an absolute bloody bargain!!!! (nothing to do with me I must add!)
which means its less than what NS Dev paid for his & we've all seen what he's done in the space of one week - set up enough demand for
exhausts to cover the cost 4 times over.
Having seen what TIG can look like I'd love to go for it, i just don't have
a) the space
b) the power feed into the garage.
http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=7619568373
This is similar to my one, managed to strap that for single phase although 80 amp draw on 240v makes the meter spin like a top if you go over 250 amps
!
Mind you usual welding is under 100amp, its the stable arc and fine control thats the key.
Regards Mark
quote:
Originally posted by MikeR
which means its less than what NS Dev paid for his & we've all seen what he's done in the space of one week - set up enough demand for exhausts to cover the cost 4 times over.
Having seen what TIG can look like I'd love to go for it, i just don't have
a) the space
b) the power feed into the garage.
(you've seen Clive's tig, its the same as his!) I asked about the Miller and he said there was no way it would run on single phase. How did you adapt yours, in case anything similar comes up?
u2u sent
I meant the one that Mark linked to Nat, There was one like yours on but it was a dealer selling it and it didn't make reserve.
I have the same unit, bought new from a aguy in Bristol for about £475 ..... awesome ..... if only I had the time to use it these days 