I'm after some 4 or 5" steel pipe to make a chimney for my log burner.

The puka flue is way over the top expensive.. £40 for a 600mm length???

Where can I get some steel pipe, like the underground stuff utility's use? must be cheaper than the named flue gear.

Even just a short length out the burner then a coil flue pipe above that??

What have you guys used as a locost solution??

Steve

get some sheet and roll one?
or if you cant roll can you make it square?

Probably no good Steve but I'll offer it to you, I've got a piece of 4" tube 43" long but I cut it down the middle when I made my bonnet former! You are welcome to them but you'll have to weld em back together down the length!

Cheers

Rich

Old hydraulic ram casing from a digger of some sort? I use to work next door to a hydraulics engineers who often had to make new rams as the old ones were right offs, only fit for scrap.

Cheap as chips here.

http://www.castorama.fr/store/raccord-poele-aluminie-PLcategorie_6599.htm

Sorry no help I know

i got lots at work U2U me if you dont get fixed up closer to home.m.