Got my Type 9 box tonight and started cleaning it up, but how do I get the release bearing off ?

look through the hole where the clutch arm sticks out, behind the arm where the bearing goes through there are two metal snap clips. If you plan to re use the bearing you have to be very careful and lever them off. I just did mine a few days ago and as I was replacing the bearing I just mashed them off and out came the bearing.

It is a fiddly job but once you see the two clips you will see what I mean.

Good luck!!!

[Edited on 20/6/11 by AndyW]

Cheers for that will give it a go tomorrow night. I guess the new one will just clip back in?

yup new one just pop's straight in!!