
I have a garage project I'm wanting to do next summer.
I want to add a second floor in the garage for storage and occasional office.
I need calculations for I beam and timber joist sizes.
Can anyone help.
It's away from houses and not noticeable from road so I need figures for safety not documents for building control.
Garage is singe skin.
Length 6.8 meters
Width 4.8 m
Roof pitch will need to be 40 degrees
I want to put a 4m dorma on one side
Roof height will be 2.1m
Tiled roof
A cost for calls would be helpful.
Front wall is 2 skin on a I beam 203x133 over garage door.
Thanks.
David
Unless you built the original garage a good place to start would be to expose the foundations, this will give an indication of what you can build on
top ?...
[Edited on 30/11/12 by woodster]
I did the footings when I built the garage and its on 600 x 1m deep.
So probably better than my house I bet :-)
Beautifully over engineered , they should be good for a skyscraper
...... Hopefully a structural engineer will be a long shortly, good luck with
the project and keep us posted
quote:
Originally posted by woodster
Beautifully over engineered , they should be good for a skyscraper...... Hopefully a structural engineer will be a long shortly, good luck with the project and keep us posted
quote:
Originally posted by woodster
Beautifully over engineered , they should be good for a skyscraper...... Hopefully a structural engineer will be a long shortly, good luck with the project and keep us posted
What are your neighbours like? Permitted development rights only allow for a single storey structure.......
No one can see it due to 10 ft conifers and where the garage is.
Footings are as per structural engineer requirements.
[Edited on 1/12/12 by jossey]