Does anyone on LCB do laser cutting? The person I used before hasn't been active on the forum for years. I have a .dxf file and I'm after getting an exhaust flange cut in stainless steel (10mm-12mm)


cheers

Some leads in this thread
http://www.locostbuilders.co.uk/viewthread.php?tid=186146

Thom at h2oprofiling just did me a custom trigger wheel at an ok price with a good lead time. Does it. Have to be laser cut? Surely water cut should be plenty good enough?

Thanks for the replies, I've fired off a few emails. Doesn't have to be laser, but from what I've read water cutting is more expensive so I was just going for the low cost option

[Edited on 12-3-2014 by Benzine]

Not on LCB but have heard good reports about this company near me. NTDWM

http://www.laserfab.co.uk/

They do laser and water cutting

Just had a look at the links above and the one that says Gutridge is the same as laserfab

[Edited on 13/3/14 by tims31]

I can recommend FastDan on this site, great communications and double checking for a set of Alfa exhaust flanges.

Regards Dan.