Anyone know of good place, round south yorkshire to get alloy and steel rods for turning in the lath. Any sizes, could do with some around 30mm dia tho.

Cheers

Get yourself up to Rufforth autojumble ( just outside York) this saturday. Get all my offcuts from there. opens about 7.30-8.00. pig to park if you go much past 9.00am. Tons of cheap lathe tools too, bring plenty of cash.
Al



Originally posted by darrens
Anyone know of good place, round south yorkshire to get alloy and steel rods for turning in the lath. Any sizes, could do with some around 30mm dia tho.

Cheers

Yes get to Rufforth,

I might even make an appearance, I'll be the fat bloke queuing next to the burger van!

Seriously I'm there for some lathe tips and a boring bar and outside jaws.

Better take a bit of coin then

See ya

Rich

me and mark keep on planning on going, plus it looks like im free this saturday. Anyone fancy meeting/bumping up there?

Locate supplies have all ally rod & bar at crowle near scunthorpe, don't know the number off hand but you can get it from directories

Joel I'll be there about 8 ish, I'll u2u my moby no

Regards

Rich

might just do that