Not car related but i know there are alot of people who know their stuff.

The cold water side of my shower has packed up. Its a TRITON LP mixer unit which has been concreted into the bathroom wall. I have removed the tiles around to have a look but it still doesn't show much.
I have found a website which does spare parts for the unit but dont know which bits to get and how to fit them.
LINK TO THE SITE HERE
I think its the knobby thingy bit that i need but how hard is it to fit?

Shower

Please help

u2u on its way
easy job
btw i meant three washhers not one
was thinkiong about the mira version


[Edited on 8/7/08 by eccsmk]

Looks very similar to my Aqualisa which I had a similar prob with.
You need to pull the knobs off the front then undo 4 screws which secure the inner unit into the body - the next bit is fun cos the inner & outer get stuck together with minerals from the water - like a sort of plastic/metal corrosion! No easy way, just clean off any c*ap you can &then gradually work the unit back & forth, tap with hammer as necessary & it should gradually come free, you then replace the "guts" of the unit with new bits at a fraction of the cost of a new shower! Best of luck!

page 18

try page 18 of this little linky