Board logo

strimmer parts
theconrodkid - 20/9/08 at 11:04 AM

ive got a kawasaki td18 engine on my strimmer,the carb isnt a walbro,its got TK cast into it but no part numbers or any other info,ive googled the whole solar system for gasket and diaphragm parts but come up with nowt,anyone got any ideas where i could get such parts?


blakep82 - 20/9/08 at 11:21 AM

what make is the strimmer?
my mum got some parts for hers, can't remember where from, but i shall find out


theconrodkid - 20/9/08 at 11:35 AM

make is marunaka no model no as the sticker is worn out.cheers.


matt_claydon - 20/9/08 at 11:40 AM

Megasquirt and bike TBs?


theconrodkid - 20/9/08 at 11:50 AM

Mat,i was thinking about putting bussa engine on it but i might have been a bit heavy


theconrodkid - 20/9/08 at 11:55 AM

http://www.youtube.com/watch?v=qAGz4i2_Iuk



me earlier today


daviep - 20/9/08 at 01:11 PM

If you got a couple of pics I might be able to help, used to repair loads of strimmers ain previous job.

What's wrong with it?

Davie


theconrodkid - 20/9/08 at 03:46 PM

prob is it wont draw fuel from the tank,same setup as my kart carb so assuming its the pump diaphragm.
ive mailed you a couple of pics ,sorry they didnt come out to well,biggles and his mate were putting me off in a spitfire and what looked like a mustang making me flatten the camera battery


daviep - 21/9/08 at 01:30 AM

Hi,

How annoying, I do recognise it but can't for the life of me remember what it was fitted to!

I'm in Indonesia at the moment and doesn't look like I'll be back in Blighty till end of October.

I'm sure you've prbobably checked already but is the breather in the cap OK and is the tank filter OK

Davie

p.s. If ir comes to me I'll u2u


theconrodkid - 21/9/08 at 06:22 AM

its on a kawasaki td18 if that helps,its the same without the cap so i recon its the pump.cheers.john.


MikeRJ - 21/9/08 at 10:07 PM

quote:
Originally posted by theconrodkid
Mat,i was thinking about putting bussa engine on it but i might have been a bit heavy


A BES? They haven't got the torque for the really sturdy weeds, you'll need to go CES for them