zetec
|
| posted on 11/1/09 at 08:17 AM |
|
|
Ford Focus central locking.
One of the rear central locking motors has died on my Focus. Anybody any tips on getting the old one out? Sure it's just nuts and bolts but
always a pain in the arse working on this sort of stuff  .
" I only registered to look at the pictures, now I'm stuck with this username for the rest of my life!"
|
|
|
|
|
focijohn
|
| posted on 11/1/09 at 09:30 AM |
|
|
From what i can remember i dont think they are too bad.....
Anyone going slower than you is an idiot. Anyone going faster than you is a maniac.
Too many targets but too few bullets.
|
|
|
jonesier1
|
| posted on 11/1/09 at 09:35 AM |
|
|
motor
r emove door panel . two small torx screws hold the outer handle on undo the rear most one and loosen the front and take the back part of the handle
off then lift and slide the main handle back and out,then 3 torx bolts on the catch,take note of the small white plastic block that locates the handle
where the torx screw is on the front end .wriggle the lump out in one lot disassemble to fit motor .hope that helps
|
|
|
zetec
|
| posted on 12/1/09 at 10:04 AM |
|
|
Ta mate will let you know how I get on!
|
|
|
