Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: siting a garden shed
nick205

posted on 7/10/06 at 09:35 AM Reply With Quote
siting a garden shed

Need to get a shed to store all the garden junk, mower, bikes etc.

What's the best way to make a base for said shed?

I've got a load of 4x2 timber which I could use like rafters to sit the shed on - is this suitable if the timbers treated properly?

Cheers
Nick

View User's Profile View All Posts By User U2U Member
Catpuss

posted on 7/10/06 at 09:45 AM Reply With Quote
I got a few bags of sand mixed with a bit of cement. Put this on roughtly leveled ground and went over it with a flat bit of wood to get it roughly level. Then laid down slabs getting them fairly level. Its been OK for a few years now.

If the posts are treated OK they would probably be fine too. I've done worse than that before. At the worst it would make a reasonable base for a couple of years.

View User's Profile View All Posts By User U2U Member
coozer

posted on 7/10/06 at 10:00 AM Reply With Quote
I just stood mine on a few bricks to keep the bottom dry.

Depends how solid your base is. A level concrete or slab base should be OK. Just keep it so the rain can drain off and that will be enough.





1972 V8 Jago

1980 Z750

View User's Profile Visit User's Homepage View All Posts By User U2U Member
Catpuss

posted on 7/10/06 at 10:09 AM Reply With Quote
Yes, drainage is important. I found that the gaps that end up between the slabs was enough for me. But then my shed is a light steel one with no base so I needed the slabs for a base.
View User's Profile View All Posts By User U2U Member
mookaloid

posted on 7/10/06 at 12:08 PM Reply With Quote
I have generally put my sheds on bearers which rest on a bed of gravel.

The gravel is easy to level off and it ensures that the bearers don't sit in contact with water which rots them.

So paving slabs which are hard work are not IMHO the best solution, buit they are a lot better than putting your shed straight onto the ground.

Cheers

Mark

View User's Profile E-Mail User View All Posts By User U2U Member
andrew.carwithen

posted on 7/10/06 at 01:39 PM Reply With Quote
I laid evenly spaced breeze blocks on their side to act as pads - digging out the earth accordingly to make them level.
Then sat the shed on treated bearers laid at right-angles to the joists of the shed floor.
Been up for over two years and is still as solid as the day it was erected.

View User's Profile View All Posts By User U2U Member
JackNco

posted on 7/10/06 at 03:13 PM Reply With Quote
used 2 work in BnQ, we used 2 recoment ppl just used slabs, cheap as ships just lay them on some sand.

John





Some people are worried about the difference between right and wrong. I'm worried about the difference between wrong and fun.
O'Rourke, P.J. (1989), Holidays in hell. London (Picador)

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
Avoneer

posted on 7/10/06 at 03:50 PM Reply With Quote
I can vouch for paving slabs.

Also treat your joists with cheap nasty creosote or equivalent and they will last for as long as the shed.

Pat...





No trees were killed in the sending of this message.
However a large number of electrons were terribly inconvenienced.

View User's Profile E-Mail User Visit User's Homepage View All Posts By User U2U Member
nick205

posted on 7/10/06 at 07:32 PM Reply With Quote
sand and slabs it is I reckon - thanks guys!
View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content © 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [© 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.