zxrlocost
|
| posted on 6/1/07 at 10:47 AM |
|
|
Sparco Harnesses shortened
Hi
when I built my last car I ordered normal Sparco harnesses these ended up way to long. due to needing 7 stlye ones
now they cost a bit and I forgot to send them back
anyone ever had them shortened
I see its quite a thick sewing thread
ta chris
|
PLEASE NOTE: This user is a trader who has not signed up for the LocostBuilders registration scheme. If this post is advertising a commercial product or service, please report it by clicking here.
|
|
|
RazMan
|
| posted on 6/1/07 at 11:08 AM |
|
|
I sent a harness back to the manufacturer (can't remember which one though) for repair of a frayed end. They did it free of charge, adding that
they were really pleased to see one of their really old models is still going strong 
My existing harnesses are way too long on the rear sections so I need to get them shortened. I wondered if a vehicle trimmer could tackle the job.
afaik it is just a cut & stitch job with possibly a little heat sealing of the fibres.
[Edited on 6-1-07 by RazMan]
Cheers,
Raz
When thinking outside the box doesn't work any more, it's time to build a new box
|
|
|
Danozeman
|
| posted on 6/1/07 at 12:09 PM |
|
|
Its thick thread used and u need a powerfull sowing machine. Im sure vehicle trimmers would do it. Even upholsterers probably would. Its not a
safety end where its shortened.
Dan
Built the purple peril!! Let the modifications begin!!
http://www.eastangliankitcars.co.uk
|
|
|
Avoneer
|
| posted on 6/1/07 at 12:38 PM |
|
|
I don't think anyone will touch them apart from the manafacturer due to the legal implications etc.
Pat...
|
|
|
procomp
|
| posted on 6/1/07 at 02:58 PM |
|
|
Hi you will usually find that most of the belt manufacturers will do alterations FOC except for the posting involved.
cheers matt
|
|
|
%20(WinCE).JPG)
