tegwin
|
| posted on 13/6/08 at 07:08 PM |
|
|
Tintop hydraulic clutch system
Im going to have to do a clutch change on a 1.6 Ford Sport Ka 2mo as my darling sister has burned the clutch out
Has anyone had any experience changing the clutch in this?.....Will I need any special tools?
And, the hydraulic system consists of a tiny little sealed cylinder on the peddlebox and then a concentric slave on the gearbox...
How exactly do you add new fluid and bleed it after changing the concentric slave over?....
Any tips on this one is greatly appreciated.
------------------------------------------------------------------------------------------------------------------------
Would the last person who leaves the country please switch off the lights and close the door!
www.verticalhorizonsmedia.tv
|
|
|
|
|
DIY Si
|
| posted on 13/6/08 at 09:43 PM |
|
|
Good luck. I did the same thing to a mate's missus Fiesta. It took me a day and a half. I had to lift the engine most of the way out of the
engine bay to get the gear box far enough over to get at the flywheel. I think there's a bleed nipple on the slave that pokes out of the bell
housing. One job I will never do again.
|
|
|
