snapper
|
posted on 2/2/13 at 01:39 PM |
|
|
Sierra steering rack parts
Finally got round to putting the Rally Design quick rack and pinion in the spare rack only to find the donor rack is less than serviceable
Pinion bearing, thrust plate and pinion seal need replacing
Probably should also do the rack sliders at the same time
So
Can you buy a rack rebuild kit?
If so who from
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
|
redscamp
|
posted on 2/2/13 at 02:08 PM |
|
|
why not exchange the standard rack for a recon,then fit the Rally Design quick rack and pinion to that?
|
|
snapper
|
posted on 2/2/13 at 02:11 PM |
|
|
Because its a lot of money a d I'm quite capable of rebuilding the one I have if I can find the parts
I eat to survive
I drink to forget
I breath to pi55 my ex wife off (and now my ex partner)
|
|
Not Anumber
|
posted on 2/2/13 at 08:47 PM |
|
|
Snapper, i dont know if its any use to you but I have a shortened but otherwise standard Sierra rack here that might be of use for parts. Pop over
next time you are near Southend. If you wanted to use the whole rack you would need to recut the internal thread on one end (or weld the rack end to
it). Anyway the rest of it would be good for parts. Swap for 2 bottles of beer sounds fair.
Chris
|
|