My own saw for the past 10 years. Ex Peugeot / Talbot factory at Ryton. Only selling as I am having a big workshop refurb and can't find space to store everything. Also has an operating manual which cost loads from lathes.co.uk

20" nominal, which is 520mm actual throat depth, tilting table, variable speed belt drive with speedo in ft/min and dust blower.

Comes with 2 off 1/4" deep blades one fine for metal, one coarse for wood.

It's 2070mm tall but comes apart to get it under lower door frames, footprint is approx 800 x 600mm.

3 phase ( I run it on a converter), I put a new starter on it when I got it 10 years ago. The tyres are a bit worse for wear but then again they were 10 years ago! Tastefully refinished in turquoise hammerite with all the care a disinterested YTS kid could muster!

I want £200 for it mainly because 90% of it is constructed out of fairly thick cast Ally and will weigh in for nearly that. But as a bonus it is relatively easy to move about and transport.

I will help load.

07903 474191 or U2U

Now sold, thanks for all the interest.