Hi,

i bought a wiring loom suitable for a pinto 2L but since have decided to fit the injection rather than the carb engine. is the wiring on this any different, i.e. will i need to make up any new wires? if so, what do i use and does anyone have any experience of what needs to be done?

Thanks,

Pete

PS The car is an MK Indy and the loom was bought from MK as well

[Edited on 10/3/04 by scoobyis2cool]

Dont know about the mk loom, but the efi loom only connects to the sierra loom in a couple of places. To drive the injection loom you need a +12v from battery +12 ignition switch, ground. the other wires back into the loom are for water temp, rev counter, etc. use the wires off the injection loom for water temp and fuel temp. I will have a look around the web sure i have seen the diagram somewhere.
regards
alistair

Thats great, thanks for that

Pete

Pete,

If you find any good info, could you share it, I am in the same situation, but keep putting it off!!

Yeah sure, I'm gonna get as much of the other stuff set up as i can first (fuel supply, cooling etc) so i can just drop the engine in, but when ive got it in and running i'll let you know how i did it!

Pete

Have attached sierra WD in acrobat format hope it works.

nope, try this link Diagram

Thanks for that, very confusing! Looks like I've got some bedtime reading to do...

Pete

I used a 2.9efi engine and loom, was a bit ago cant quite remember but the 2.0efi is very similar, did you get all the wires from original car, including tfi mod. I think there is only one or two connectors where the efi loom joins the car loom. I will have a look at the diagram and see if I can mark the wires.

This document may or may not be of use, eectch98.pdf