is there a standard PCD for fuel gauge senders?


Description

want a blanking plate done. decided instead of doing it myself,, i'm going to get a whole load of drawings done to get everything water jetted instead.
and i'm rubbish at working out PCDs unless theres a even number of holes

i dont know about pcd but i do know that with my VDO sender the holes are NOT evenly spaced so it can only go back in one position, the holes are not out by much, cant see with naked eye so check yours

ooh, thanks for that, i'll check. that top left one doesn't look evenly spaced with the 2 either side of it...

or has anyone got an old broken fuel gauge sender that might fit. i don't particularly want a fuel level sender at the minute. just need something to fill the hole. particularly interested in the rubber gasket too. otherwise it'll be instant gasket everywhere

[Edited on 5/10/09 by blakep82]