Afternoon everyone.

Another Question regarding the Type 9 install.

Where the clutch fork pivots in the bell housing (standard ford unit) there was a
rubber sleeve. When I cleaned the bellhousing it fellout in 2 pieces. The reamains
felt like silicone.

Does anyone know if there is a source of replacement or a real locost method.

Thanks.

Len.

Never seen one of those so you probably dont need it
Ray

is it this sort of pivot?

Or is it this type?

SBD's pivot

Hi guys, the pivot looks like the photo that 'stevegough' has posted.

The clutch arm is different though.

The arm is like a 2 fingered prong that just slips onto the pin and the rubber bush would prevent it rattling .

Len.

This link takes you to a Burton power arm that is identicle in my photo archive.


ford clutch arm

[Edited on 13/2/11 by avagolen]

I have now found this on the burton website.


Anti Rattle Sleeve Burton Powe

[Edited on 13/2/11 by avagolen]

[Edited on 13/2/11 by avagolen]

[Edited on 13/2/11 by avagolen]

[Edited on 13/2/11 by avagolen]

[Edited on 13/2/11 by avagolen]

Glad to be of help!