Looking for a 3D model of the audi 4.2 V8 (ABZ or similar) to work with but can't find one. Anyone got any secret hidden repositories of drawings?

Been looking for one of these for ages as ive got a set of plans that i want to test fit the engine into,

Closest ive gotten is really vauge but


The approx sizes of the Audi ABZ V8 engine and gearbox are: -

Total length (Audi ABZ engine + 01X gearbox) = 1200mm (47 1/4"
Length of engine (front pulley to bellhousing face) = 490mm (19 3/16"
Length of 01X gearbox (bellhousing to rear casing) =710mm (27 15/16"
Max width of engine (across exhaust manifolds) = 760mm (29 15/16"
Max height of engine (sump to idle air valve) = 660mm (26"
Drive shaft position (front pulley to centre of drive flange) =690mm (or from gearbox rear casing = 510mm) (20" (27 3/16"



http://www.motorgeek.com/viewtopic.php?f=6&t=19049&start=25

huge amounts of Info Including the copy/pasted stuff above about allsorts of V8's


Shaun

Cheers. I've got one in the post so I'll measure and draw up a model when it lands

That sounds brill you going down a nice mid engined route?


Sheep

Yup, finally made a decision. Middy monster

cool i have plans for about 5 midi cars just want to be able to squeeze that lovely engine in

Sheep

It's just a shame the laser scanner at work is too small to fit the engine in

just take it to pieces first

Sheep

Ha. not with the cost of gasket kits for them!